收藏本ye 您好,huan迎来到shang海dongtai澳门盘,jiang竭诚wei您服wu!    工作时jian:shang午 9:00 - xia午 18:00 温馨提示:
EHS 网站
热门sou索:
防火柜、安全柜、化学品柜、工业安全锁具、盛漏托盘、吸fu棉套zhuang等工业安全与环保产品;实验台、实验shi家具、通feng柜、实验柜等实验shi设计gui划、生产、安zhuang及配件;离xin机、防爆工具、烘xiang、超shengbo清洗机、水质监测仪qi及实验shi耗材等共3大类产品。
产品分类
品牌专qu >>更多
Ultra-EverDry?应yong指南|shang海dongtai澳门盘实验shi设bei有限公司
Ultra-EverDry?应yong指南
 
.Ultra-Ever Dry? SE 7.6.110 is a solvent based two part (top and bottom) coating system. It is suitable for indoor or outdoor use. The system offers superhydrophobic and superoleophobic performanceand has been shown to maintain a high level of performance
under a variety of conditions and for extended time. The system is useful for non-wetting, anti-icing, self-cleaning, anti-bacterial, and for corrosion protection.
Ultra-Ever Dry? SE 7.6.110是一zhong溶剂型涂层(表面和打di两个部分)。适yong于shi内或shiwai应yong。已jing证明其可以zai多zhong条件xia和较长时jian内wei持超强的疏水和疏油性能。该涂层对于防潮、防结冰、自洁,**、防腐蚀等都非常有yong。
 
.Ultra-Ever Dry? SE 7.6.110 yields a matte finish surface that withstands moderate abrasion. The coating is translucent white in appearance depending on thickness used. Ultra-Ever Dry? SE 7.6.110 is applied in two steps using an equal application volume of bottom coat and top coat.
Ultra-Ever Dry? SE 7.6.110 ?SE产生一个哑光表面可以承受适度的摩擦。涂层材料呈半透明白色白色的浓度则取决于喷涂厚度。Ultra-Ever Dry? SE 7.6.110 ?SE喷涂作业分两个步骤yong相同量的打di层和表面依ci喷涂。
 
.CAUTION: Items coated with Ultra-Ever Dry? will have a translucentwhite appearance which could affect the color of the product being coated. TEST ON AN INCONSPICUOUS AREA PRIOR TO FULLY COATING.
注意Ultra-Ever Dry?涂层呈半透明白色可能会影响到产品本身的色彩。suo以建议您zaishiyongqianzai一些不显眼的部位xianzuo一xia实验,以确定不会对您的产品造cheng影响hou再shiyong。
 
.Personal Protection Equipment:
个人防护设bei:
Always wear the following equipment when applying:
zaishi工作襠ao讨衠ingshiyong以xia个人防护设bei:
Respirator - NIOSH approved half-face respirator P100 rating with organic vapor cartridge
呼吸qi:NIOSHhe准的半面zhao式dai有机蒸汽滤盒的呼吸qiP100
Safety glasses/goggles
安全眼睛/护目镜
Nitrile gloves
ding腈手套
 
wu.Application Equipment Options:
shi工设bei选项:
Option A: Pneumatic Sprayer
?选项A:气dong喷雾qi
Air compressor
空压机
Conventional gravity fed, pneumatic sprayer, requires two separate sprayers
常gui的自dong给料气dong喷雾qi,需yao两把单独的喷雾qi
Note: Remove the pre-installed filters in the sprayer head
注意: 拔除喷雾qitoushangyuzhuang的guo滤嘴
Air pressure = 20-35 psi (138-241 kPa) nozzle
气压=20-35psi(138-241kpa)喷嘴
Tip size = 0.020-0.050 inches (0.50-1.27 mm)
顶端尺cun=0.020-0.050英cun(0.5-1.27mm
 
Option B: Pump Sprayer
?选项B:气压式喷雾qi
Two hand pump sprayers, one for top coat and one for bottom coat.
两个手dong气压喷雾qi,一个yong于打di涂层、一个yong于表面涂层
Pumps must be compatible with solvent in coating.
气压喷雾qi必须适合于溶剂类涂料
Xylene for bottom coat and Acetone for top coat.
打di涂层含有二甲苯,表面涂层含有丙tong。
Adjustable tip size to provide fine mist.
可调节的喷嘴可以提gong*适合的厚度
 
Option C: Trigger Sprayer
?选项C:扳机式喷雾qi
Two trigger sprayers, one for top coat and one for bottom coat. Usually available in quart (950 mL) sizes.
两个扳机式喷雾qi,分别yong于打di和表面涂层。通常可提gong1夸脱(950 毫升)容积大xiao。
Pumps must be compatible with solvent in coating.
扳机式喷雾qi必须适yong于溶剂类涂料。
Adjustable tip size to provide fine mist.
可调节的喷嘴可以提gong*适合的厚度
 
wu.Optional Equipments
?fu件设bei
Heat gun or blow dryer to speed up drying process.
热feng枪或者吹feng机yong于加速ganzaoguo程
Xylene for cleaning     
二甲苯清洗
Spreading Rate (coverage):
涂布率:
150-180 sq ft/gal (3.68-4.42 m2/L)
150-180pingfang英尺/加仑3.68-4.42pingfang米/
 
liu.Application:
应yong
Surface Preparation: Remove all oil, grease, dust, dirt, loose rust, and other foreign materials to ensure adequate adhesion of bottom coat. Sanding of the surface with 150 grit silicon carbide sand paper can enhance surface adhesion.
表面处li:qu除suo有的油、油脂、粂e尽⑽酃浮⑹杷尚獠慵捌渌煳铮匀繁4騞i涂层良好的fu着力。ru果您shiyong150#砂纸打磨表面的话可以提高表面fu着力。
Step 1: Bottom Coat
步骤1:打di涂层
Shake the can of bottom coat well and pour into dedicated sprayer.Once sprayer is filled to the desired amount, shake well and apply multiple thin and uniform coatings to obtain a wet thickness of 3.0-5.0 mils (76-127 microns). This will form a dry film thickness of 1.0-1.5 mils (25-38 microns). Some agitation during application is recommended. Avoid over wetting or pooling. Allow 15 to 20 minutes of drying time before applying top coat. A heat gun or blow dryer may be used on low setting to speed up drying time.
摇匀打di涂层,daoru专yong喷雾qi。注man喷雾qi以hou摇匀,多ci薄而jun匀的喷涂到3.0-5.0 mils (76-127 microns)。当ganzaohou厚度会zai1.0-1.5 mils (25-38 microns)。建议zai作襠ao讨胁籺ing晃dong喷雾qi。避免guo于潮湿的环境和水池。打di涂层喷涂hou需yao等dai15-20穤hong樱琩ai其ganzaohou再行表面涂层喷涂。热feng枪或者吹feng机可以加速ganzao的guo程,缩duan固化时jian。
Step 2: Top Coat
步骤2:表面涂层
A separate sprayer used only for top coat is required. Shake the can of top coat well and pour into sprayer. Once sprayer is filled to the desired amount, shake well and apply multiple thin coats. Do not overcoat. Use an equal volume of top coat to cover the bottom coat. Some agitation during application is recommended.
表面涂层必须shiyong一个单独喷雾qi。摇匀表面涂层,daoru喷雾qi。注man喷雾qi以hou摇匀,多ci薄而jun匀的喷涂。不yaoguo多的喷涂,shiyong相同的量fu盖打di涂层。建议zai作襠ao讨胁huan系幕蝑ong喷雾qi。
Avoid over wetting or pooling. The top coat will produce a translucent white appearance.
避免guo于潮湿的环境和水池。表面涂层jiang呈xian白色半透明的wai观。
Step 3: Drying/Curing of System
步骤3:ganzao/固化fang法
The coating will become superhydrophobic within 30 minutes of the top coat application. For best results, allow 2 hours of drying time. A heat gun or blow dryer may be used on low settingto speed up drying time.
涂层的超疏水性能会zai喷涂表面涂层以hou30穤hong幽诔蕏ian。*佳效果大概需yao2个xiao时的ganzao时jian。ru果shiyong热feng枪或者吹feng机jiang加速ganzaoguo程,缩duan固化时jian。
Step 4: Cleanup:
步骤4:清li:
Clean tools/equipment immediately after use with xylene. Empty left over top or bottom coat into original containers.作业houli即shiyong二甲苯清li工具/设bei。剩余的表面或打di涂层dao回原容qi内。
 
.Care and Repair:
wei护与保养:
Ultra-Ever Dry? is a durable coating that exhibit superhydrophobicityand superoloephobicity. After curing the coatings will repel water mixtures and refined oil. Cleaning of the surface should be performed using low pressure water spray. The surface
should demonstrate self cleaning properties under these conditions. Dust and dirt should rinse off easily. The surface will remain completely dry. The surface will lose it properties if treated with detergents, soap, some solvents or high pressure water.
 Due to the natural oils in the skin, excessive handling with bare hands of treated materials can cause a reduction in performance as can severe abrasion.
Ultra-Ever Dry?必须同时shiyong两zhong涂层fang可呈xian超疏水与超疏油特性。当涂层完全固化hou可以抵kang水混合物和精炼油。qingshiyong低压水喷雾来清洗表面,zai低压水流的冲洗xia表面jiang会实xian自洁。粂e疽约拔酃竕iang非常容易被冲洗掉,表面jiang保持完全ganzao。洗涤剂、肥皂、某些特别溶剂或是高压水流jiang会影响涂层表面部分性能。皮肤中含有tian然油脂,箂hi嗟耐绞纸哟ヅ缤kang谋砻嬉嗫赡芑嵋騳anzhong磨损而致表面性能xia降。
 
 
 
Instructional Video available at www.UltraEverDry.com-or-Scan this QR Code with your smart phone.
 
 
也可咨询:021-69106488

shang海dongtai澳门盘jjiangwei你服wu!

产品链接:http://www.caisonglabs.com/s04/caisonglabs/sjml/20130308/3049448/1.html
 
Copyright? 2003-2020  shang海dongtai澳门盘实验shi设bei有限公司版权suo有
电话:021-69106488 021-69106624 传真:021-69106489 di址:shang海市松江quguang富林路658弄3号写zi楼1410shi 邮编:201620

沪ICPbei13012389号    

沪公网安bei 31011402005026号